Section

Q no.

Question

Cutting

裁剪

1

Check if there are proper control of pile height for cutting?

是否有檢查拉布高度？

Cutting

2

Check if the production marker with panels are properly laid flat, overlapped with proper special marker, cut by pieces using appropriate scissors/ band knife/ die cut/ lazar cut…etc.? 

有無檢查嘜架是否正確的平輔，是否有重疊和標記，使用適當的剪刀/帶式刀/打孔機等？

Cutting

3

Is there proper control for matching / cutting of patterned fabrics such as plaids & stripes? (Only for plaids/ stripes)

裁剪時是否合理控制條字布和格子布使其對條對格？

Cutting

4

Is spreading methodology is found with appropriate  tension; stretch /knit fabric relaxation process correct, PU and leather in correct shading separation, suitable controlled environment condition for relaxation/ temporary storage ?

是否使用適當的力來拉布以避免張力，針織布的松布程序是否正確，PU和皮革是否正確的分開色差，是否在適當的環境松布，松好的布是否儲存在受控區？

Cutting

5

Is there roving QC checking cutting accuracy?

QC有無檢查裁剪的精確度？

Cutting

6

Are cut pieces properly inspected and numbered?

裁片有無檢查和編號？

Cutting

7

Does factory has good housekeeping on leftover fabric/ cut panels/ waste fabric?

對每匹布裁剩的布尾有無很好的記錄和保存，以備配片之需？

Cutting

8

Is there work-in-progress balance between cutting and production output to adequately fulfill daily production requirement?

是否有衡量裁剪和其他生產過程的產量足以達到日產能要求？

Cutting

9

Indicate fusing method used? - Hand Iron , trouser steam press, small piece fusing press, continuous roller fusing press.

燙襯用的是熨斗、蒸汽壓力機、小的熔化塊還是滾筒式熔化機？

Cutting

10

Is fusing quality acceptable, machines regularly calibrated and records maintained?

燙襯質量是否可接受，機器是否定期較準和維護并保存記錄？

Cutting

11

Are bulk cut goods and trims, designated for either internal or off-premise handling (such as sewing, laundry, embroidery, printing), transported in a well-organized and protected manner?

在內部或外部處理（如縫制、水洗、繡花、印花）的產品和輔料在轉送或運輸過程當中是否有序且受到保護？

Cutting

12

Is there metal/ needle control policy implemented?

是否實施金屬和利器控制程序？

Cutting

13

Are all machines in good conditions/ setting and maintenance? Wiring?

機器是否狀況良好并定期維護？

Cutting

14

Is the molding process in consistent setting and operating? 
沖壓過程是否持續設定和運行？